0
Add your answer:
Earn +20 pts
Can you put a brine lacrosse shaft on a warrior head?
It shouldn't matter. Any head should fit on any shaft
Can you put a brine lacrosse head on a warrior shaft?
ya it should fit fine cuz i have the brine answer for a head and a warrior hero composite for a shaft. it works fine but im getn the brine swizzle shaft soon so ya
Can you put a brine head on an easton shaft?
I'm pretty sure any boys head will fit on any boys shaft and any girls head will fit on any girls shaft
Will a warrior mojo lacrosse head fit a brine swizzbeat shaft?
Yes, I have a Warrior Mojo head on my Brine Swizzbeat Shaft and I love it. So if your going to try this out, then yes it will work.
Can a brine head fit on a stx shaft or will it be loose?
to make the head not loose put a wine cork in the shaft and screw through that to keep ypur head in place
What lacrosse shafts does the Brine Clutch 2x fit on?
the brine clutch head will fit on any brine lacrosse shafts. I have the Clutch on my brine swizzebeat. i recommended this shaft its is light gripy and cheap. it is only 80 dollars
Can you put a brine shaft head on a warrior head?
I am pretty sure it does because brine heads fit on warrior shafts, so they should be the same size
What lacrosse heads can fit on the Brine Swizzle?
any type of head except for a crank shaft head because it is bent. But any kind of head should fit.
What shaft does the brine clutch fit on?
Almost any shaft but on some you need to tape it on. All shafts fit on a brine clutch and the best shafts are totally preference
How do you fit a brine shaft to a de beers head?
put the shaft in the freezer for 3 minutes and use a hair dryer and use it by, heating all around the throat area (where the shaft meets the head) of the head for 1 minute should go on easily after that
What lacrosse shafts does the Brine Clutch fit on?
ANY BRINE SHAFT AND SOME WARRIORS (EX) WARRIOR DIAMOND
Can a harrow lacrosse shaft fit on a brine lacrosse head?
Yes, It may take a little bit of pressure, but it eventually will slide on. If you have trouble, run the throat (bottom part of head that connects to shaft) under some hot water, and then try sliding it on (this will soften up the plastic)
