almost every head fits on every shaft. Excluding the kyle harrison sticks and head which have a tilt and only work on the stx cranckshaft 10degree shaft
Any head can be put on any shaft. All you have to do is put the bottom of the head in warm not boiling water, just warm tap water for a few minutes and it should slide rite on to your maverick shaft if it doesn't already.
It probably will. You might just have to drill a hole. Maverick juice is the worst head ever...just saying
yes, i have a stx head on a brine shaft. yes, i have a stx head on a brine shaft.
I would recommend that you do put a crank shaft head on a crank shaft. Putting any other type of head on a crank shaft could possibly break the head.
I'm pretty sure any boys head will fit on any boys shaft and any girls head will fit on any girls shaft
Any head will fit on any shaft. But if you but a head on a shaft that is a different brand than the shaft, you may need to drill a new hole into the shaft. The only exceptions are the STX Crankshaft shafts which need certain heads.
no, the cam shaft is on the engine cylinder head..
It shouldn't matter. Any head should fit on any shaft
Yes. You may need to drill a pilot hole into the shaft to affix the head.
Tail Shaft is the section after the propeller shaft of a shift. Any shaft is always placed farthest from the head, where the power is applied.
Yes, you can use any head besides the STX duel head. If the head you use is too big for the shaft, put tape on the shaft until the head fits snug. If it is too big for the head, head the throat of the head with a blow dryer and slide the head on.
to make the head not loose put a wine cork in the shaft and screw through that to keep ypur head in place