Stx lacrosse heads DO fit on brine shafts.
a warrior head can fit on any shaft it might be a bit loose though and you might have to drill a new hole.
I am pretty sure it does because brine heads fit on warrior shafts, so they should be the same size
sure y not
Any head will fit on a warrior lax head because all shafts are the same.
Heads are usually universal. You may have to drill a new hole in the shaft though.
Yes. In fact, any head can go on any shaft.
ANY BRINE SHAFT AND SOME WARRIORS (EX) WARRIOR DIAMOND
No they fit all standard shafts.
yes they do. i personally have a stiffi on a vanadium and it fits just fine.. you may need to put a piece or two of tape around the shaft under the head if its a little too small
it will fit on shafts make sure the shaft is mens and it's a little harder to put on a crank shaft. if this is a real problem take it to the nearest lacrosse store and ask them why and if i burned out of shape go to where you bought it and see if you have a warranty (most heads do)
No reebok does not fit with other shafts without adapter and some just dont fit
any mens head can fit on any mens shaft. i put warrior, brine and gait heads on STX and harrow shafts all the time. the only thing that is different between different brands is where the screw hole is located but alot of people just tape their heads on their shafts anyway. i however are one of those people who like to screw their heads on their shafts but i have found that i can drill a new hole myself by using a 1/8 drill bit. it makes the perfect sized hole for the screw. please add me to your saved sellers on ebay, ihave awesome deals on the top lacrosse gear
Yes, all heads fit on all shafts, unless you have a Gait with a 10 degree offset head in which case only the TOS heads work on those
the brine clutch head will fit on any brine lacrosse shafts. I have the Clutch on my brine swizzebeat. i recommended this shaft its is light gripy and cheap. it is only 80 dollars
All maverick shafts and all stx shafts except the bad ones like the alloy n it does fit on brine shafts but u will probably need to drill a new hole. Hope that helped.
any head will fit on any shaft. It just might take a little elbow grease
there are some gait ones that fit
Any head will fit on any shaft. But if you but a head on a shaft that is a different brand than the shaft, you may need to drill a new hole into the shaft. The only exceptions are the STX Crankshaft shafts which need certain heads.
Yes. Most head wil fit on shafts made by the same company
well it may depend on the type of stx head or warrior shaft,,, usually they can but you may have to drill a new hole. i had an stx proton power on my warrior krypto pro, and all i had to do was drill a new hole.... hope this helped :)
Any head can be put on any shaft. All you have to do is put the bottom of the head in warm not boiling water, just warm tap water for a few minutes and it should slide rite on to your maverick shaft if it doesn't already.
Yes, however you'll possibly have to drill a new hole
the stx G22 10 degree, K18 10 degree, Kannon 10 degree and the X3 10 degree heads