yerf dog
To install a chain tensioner on a Yerf Dog Go Kart 3206, first, locate the chain tensioner kit which typically includes the tensioner, mounting hardware, and possibly a bracket. Begin by positioning the tensioner near the rear axle where the chain runs. Secure it in place using the provided bolts, ensuring that it applies light pressure to the chain. Finally, adjust the tensioner as needed to achieve the correct chain tension and ensure smooth operation.
yerf dog is a good brand and if u can find them cheap on craigslist.
The Yerf-Dog go-kart model 3203 typically uses a 1/2" x 3/4" belt, commonly referred to as a "CVT drive belt." It's essential to verify the specific model and year, as variations may exist. Always check the owner's manual or consult with a parts supplier for the most accurate information regarding replacement belts.
Place woodblocks under the rear frame of the go-kart to raise it off the ground. Remove the belt guard by pulling out the cotter pin. Position the belt beside the clutches so that the arrow printed on the top is pointed toward the front of the kart. Wrap the belt around the clutch attached to the engine, then wrap the other end of the belt around the clutch. The belt should not make it completely on the second clutch. Rotate that second clutch while pushing the belt into position. It will slide on as the clutch rotates.
The serial number on a Yerf Dog typically can be found on a metal plate or sticker attached to the frame of the vehicle. Common locations include near the rear axle, on the driver's side of the frame, or under the seat. If you have trouble locating it, consult the owner's manual for specific details related to your model.
in a collar
Yerf dog go karts can go as fast as any other go cart. When you buy one you should look at the engine size. If your 6' and weight 220lb the you probably don't want a 110cc go cart. the bigger the engine the more power, torque and speed you get. If you want a fast go kart then i would get one with a 250cc engine. so yerf dog karts don't have a "max speed". There speed depends on the engine. What you really should be looking for is torque not speed. Ya going fast is fun but if your kart doesn't have enough torque to get you up to a good speed then what's the point. plus more torque gives you a better take off. If your kart has low torque, and if your one of the people that likes to spin the tires when taking off then your gona be in trouble. So before you buy, be shure to look all these thing up before making a decision. Hope this helped
The Yerf Dog company makes go-karts. Some of the go-karts for very young children were recalled in June, 2005 for irreparable safety hazards from breakages.
Should be stamped on th frame under the seat prefixed and ended with a *. What model makes a difference.
The oil-to-gas ratio for a 2000 Yerf Dog 90cc ATV is typically 40:1, which means you should mix 3.2 ounces of 2-stroke oil per gallon of gasoline. Always refer to the owner’s manual for the most accurate specifications, as recommendations can vary. Using the correct ratio is crucial for optimal engine performance and longevity.
THERE IS NO GOVENOR ON THE YERF DOG. LISTEN TO THE RPMS DUDE YOURE AT FULL MAXIMUM THROTTLE HOWEVER YOU COULD RUN NITROMETHANE WITH A OZ. OF WD 40 AND BOOST YOUR POWER AND SPEED. I GOT UP TO 65 MPH BEFORE THE BACKEND BLEW UP AND THE FIRETRUCKS ARRIVED. FORGET ABOUT THE REVERSE GEAR. YOU WOULD HAVE TO PUT IN A NEW TRANSMISSION. jUST BUY A NEW GOCART WITH REVERESE IF YOU WANT THAT AROUND 2500$. KEEP ON BURNING!