0
What else can I help you with?
Where is the VIN number on a yerf dog?
in a collar
Where is the VIN on a yerf dog?
Should be stamped on th frame under the seat prefixed and ended with a *. What model makes a difference.
What is the best go kart manufacturer?
yerf dog
What size belt is on a yerf-dog go-kart 3203?
The Yerf-Dog go-kart model 3203 typically uses a 1/2" x 3/4" belt, commonly referred to as a "CVT drive belt." It's essential to verify the specific model and year, as variations may exist. Always check the owner's manual or consult with a parts supplier for the most accurate information regarding replacement belts.
The Yerf Dog company is in what line of work?
The Yerf Dog company makes go-karts. Some of the go-karts for very young children were recalled in June, 2005 for irreparable safety hazards from breakages.
How fast does a yerf dog go kart?
Yerf dog go karts can go as fast as any other go cart. When you buy one you should look at the engine size. If your 6' and weight 220lb the you probably don't want a 110cc go cart. the bigger the engine the more power, torque and speed you get. If you want a fast go kart then i would get one with a 250cc engine. so yerf dog karts don't have a "max speed". There speed depends on the engine. What you really should be looking for is torque not speed. Ya going fast is fun but if your kart doesn't have enough torque to get you up to a good speed then what's the point. plus more torque gives you a better take off. If your kart has low torque, and if your one of the people that likes to spin the tires when taking off then your gona be in trouble. So before you buy, be shure to look all these thing up before making a decision. Hope this helped
What are some good off road go kart brands that are sold for cheap?
yerf dog is a good brand and if u can find them cheap on craigslist.
What is the oil ratio for a 2000 yerf dog 90cc ATV?
The oil-to-gas ratio for a 2000 Yerf Dog 90cc ATV is typically 40:1, which means you should mix 3.2 ounces of 2-stroke oil per gallon of gasoline. Always refer to the owner’s manual for the most accurate specifications, as recommendations can vary. Using the correct ratio is crucial for optimal engine performance and longevity.
How do you change the belt on a yerf dog motor?
Place woodblocks under the rear frame of the go-kart to raise it off the ground. Remove the belt guard by pulling out the cotter pin. Position the belt beside the clutches so that the arrow printed on the top is pointed toward the front of the kart. Wrap the belt around the clutch attached to the engine, then wrap the other end of the belt around the clutch. The belt should not make it completely on the second clutch. Rotate that second clutch while pushing the belt into position. It will slide on as the clutch rotates.
How do you take the govenor off your 7hp yerfdog gocart - where is it located And is it possiblehow much would it cost to add a reverse and a shifter?
THERE IS NO GOVENOR ON THE YERF DOG. LISTEN TO THE RPMS DUDE YOURE AT FULL MAXIMUM THROTTLE HOWEVER YOU COULD RUN NITROMETHANE WITH A OZ. OF WD 40 AND BOOST YOUR POWER AND SPEED. I GOT UP TO 65 MPH BEFORE THE BACKEND BLEW UP AND THE FIRETRUCKS ARRIVED. FORGET ABOUT THE REVERSE GEAR. YOU WOULD HAVE TO PUT IN A NEW TRANSMISSION. jUST BUY A NEW GOCART WITH REVERESE IF YOU WANT THAT AROUND 2500$. KEEP ON BURNING!
