Yes, a Lacrosse head can be put into hot water to soften the netting. Just be sure that the water is not boiling as it could either melt or weaken the plastic structure of the head. However, the best way to loosen the netting on a lacrosse head is to break it in by using it.
rit die hot water container that fits lax head and water in it hot glue gun (optional) and time
Yes, It may take a little bit of pressure, but it eventually will slide on. If you have trouble, run the throat (bottom part of head that connects to shaft) under some hot water, and then try sliding it on (this will soften up the plastic)
Most waxes will soften if you put it into a bowl of hot water. If you put butter into the same bowl, it will also soften.
sSeal in ziploc and put in hot water. or microwave 3-5 seconds
Run the throat and the upper part of the shaft under some hot water. Not boiling hot, but enough to loosen up the plastic so it'll come off more easily.
Yes, exposing cork to hot water can cause it to lose its shape and shrink. It is advised to avoid using hot water on cork materials to prevent this from happening.
To clean a Lax head you take out all of the mesh and then bleach the head.
Soften the rubber by immersing them in a bowl of hot water. You might also find them easier to fit if you apply a little grease to the mouths of the carbs.
Adding hot water to pot noodles is a physical change. The hot water causes the noodles to absorb the water and soften, changing their physical state without altering their chemical composition.
Hot water can soften silicone but it will not cause it to shrink. To shrink silicone, heat must be applied evenly through a process like baking or exposure to high temperatures.
out it over your stove to heat it up and once it is hot start pulling it to stretch it once it is as wide as you want it let it cool.
very hot weather, or water. Take a shower in hot water, not cold.