No. they have two different receivers.
No. The trigger assembly for the a5 is set up very different from the 98 custom.
No, the screw set is off and there is holes for the cyclone feed.
Yes all 98's are interchangeable no matter the model. But if you haven't taken apart a paintball gun before it could cause problems. When i was putting a new trigger in my 98 the second i lifted one half off about 3 springs shot off. I had to get my owners manual and look to see where all the springs went. Took about 15 minutes longer than it should have. But was worth it in the end.
NO!
98Shooter:Sorry i can't answer your question completely but i know off the top of my head that it uses a 3/16" for velocity adjustments.
You need to take apart the entire blaster to get the stock off once you attach it. Just unscrew the screwsso that you can take off the top, and take it out. Then screw the screws back in after putting the shell back on. Stinks, huh?
No, that's a Japanese custom.
Take off your shoes before you come into there house.
depends on the lee enfield but to take down my lee enflield, first i take the butt plate off, then with a long flat head screwdriver i take out the rear scew holding but butt end of the stock off. then i take the cross screw off the floor plate, and remove the screw holding the floorplate and fore arm to the receiver and then the stock is off
Bugatti Veyron which will run you over a million dollars to buy. There are custom vehicles that come with more, but this is a stock off the shelf vehicle.
one japenese custom is that when entering a home you must take off your shoes.
Remove the buttplate, shone a light in the hole in the center of the stock. You should see the head of a bolt. Using a socket and an extension, unscrew the stock bolt. Stock should slide off.