0
becasue they're fake
Add your answer:
Earn +20 pts
Why wont Tech Deck live let you on?
Cos you're a douche
How do you make your Tech Deck cooler?
get a sharpie[black] and colour the tech deck sign the colour of the sharpie wont blend in unless you lightly dot over it until you cannot see any whit left it will look like a super cool tech deck !!!!!!!! [you can also colour the grip tape with a crayon
Can you color a Tech Deck with a sharpie?
Most likely u wont see it &+ its going to go through your grip taped and ruin your board so i would say no. cool hope this helps :)
Why wont let me log in on Upper deck u?
it is just not working. OK
How do you tighten deck belt cub cadet 1046 mower?
check the spring on the idler wheel, is there somthing stopping it from moveing ?is it streched out , if not do you have the correct size belt on it ? it may be streched out of size, if it wont tighten up install a belt 2 inches shorter, some times the springs loose the strech, and wont pull as much
What happens if you tighten the nut all the way on a skateboard.?
If you do that the trucks wont turn, wheels wont rotate, and the board will get stress fractions from the nuts being to tight so you probably wont be going anywhere
Why did my serpentine belt slip off can you tighten it its loose now and wont recharge battery?
1992 4.3l engine
How do you adjust tailgate lock BMW 525?
loosin the nut on the in side on the trunk adjust it where you wont it then tighten it back
Why wont it let you leave your deck with a god card in your deck in Yugioh gx spirit caller?
Because it's a forbidden card, and you need lvl 99 to play those.
Is suite life on deck finishing will there be more episodes?
yes there finished 4 good there wont be anymore episodes :(
Why wont my mobile home furnace Coleman Model7655-856 turn on?
Check the thermocouple, or find a gas tech to do it.
How do you take out the motor mount in 2006 Chevy Cobalt?
have a jack and piece of wood handy. 1. roll the jack under the oil pan with the wood on top and raise til it touches the oil pan so when you loosen the bolts and/or nuts the engine wont drop 2. loosen the bolts for the mount 3. remove the mount 4. raise the engine up a little til its about even where it was with the mount in 5. replace the mount and tighten up 6. lower jack and check the nuts and/or bolts to ensure they are torqued to specs
