Yes, a 1995 RM 125 motor can fit into a 1990 RM 125 frame, but there may be compatibility issues that need to be addressed, such as mounting points, wiring harness connections, and exhaust alignment. It's essential to check specific measurements and components, as well as potential modifications required for a proper fit. Overall, while it's feasible, careful consideration and adjustments may be necessary for a successful swap.
yes it can i have done it
No a 125 frame is too small to fit a 250 motor but with a cutting torch and a welder anything is possible.
yes it does fit but u mite have to get new motor mounts for it but that about it, it should mount rite up then
with a little snipping there should be no problem. if you don't mind doing a little hand work. it's possible because i slapped 1999 yz 250 plastics on my 1990 yz 125.
A 1995 and 1996 are similar but not the same some parts might be interchangable but they changed the styling then and so I would assume they changed the frame some too. I would not count on them being the same.
There may be clearance for the motor to fit in the frame, but you will have to modify the frame to bolt the motor into it. A main concern would be how the back of the motor lines up for the swingarm shaft to go through. Also will the carb intake boot line up with the airbox boot? A lot of questions you wouldn't know until you (or someone else) tries it.
Will a 94 rm 125 engine fit on a 2000 rm frame?
on the frame
The yz 125 is better because 2005 and up have An aluminum frame and over all better. The kx 125 is ok but they made an aluminum frame in 2007. I would always go with yamaha
Chiquititas - 1995 4-125 is rated/received certificates of: Argentina:Atp
Chiquititas - 1995 5-125 is rated/received certificates of: Argentina:Atp
Chiquititas - 1995 6-125 is rated/received certificates of: Argentina:Atp