first drain your old oil with the drain plug on the left hand side of the bike, replace oil drain plug. then remove the oil fill level plug on right hand side of the bike on engine casing. add oil(15w50 is spec i think, but dextron atf works), until it begins to run out of the hole when the bike is level. replace plug, replace oil fill cap. have fun
Remove the Suzuki 450 oil pan plug. Allow the oil to drain out of the oil pan. Replace the plug to the oil pan. Fill the motor with oil.
Start the bike up and ride it or let it idle for a few minutes to war the oil up in the engine. Then kill the engine and loosen the drain plug on the bottom of the engine. Let all of the oil drain out and replace and tighten (careful to not overtighten) the drain plug.
Start the bike up and ride it or let it idle for a few minutes to war the oil up in the engine. Then kill the engine and loosen the drain plug on the bottom of the engine. Let all of the oil drain out and replace and tighten (careful to not overtighten) the drain plug. Remove the filler plug and add your oil.
Start the bike up and ride it or let it idle for a few minutes to war the oil up in the engine. Then kill the engine and loosen the drain plug on the bottom of the engine. Let all of the oil drain out and replace and tighten (careful to not overtighten) the drain plug. Remove the filler plug and add your oil.
Run engine to warm up the oil undo sump plug drain old oil. Replace with the correct oil and amount.
10mm bolt on the left side in front of the gear shifter, and right in front of the 12mm trans drain plug.
KTM recommends Motorex Power Synt 4T 10W50
You drain the engine oil from the drain plug on the bottom of the oil pan.You drain the engine oil from the drain plug on the bottom of the oil pan.
Start the bike up and let the oil warm up (side of the cylinder should be pretty warm to touch) before killing engine. Remove drain plug (on bottom of engine) and let all oil run out. Replace drain plug and remove filler plug on side of cases and add oil.
On the bottom side of the cases either in the center or at the back (towards the rear wheel side of cases).
Start the bike up and let the oil warm up (side of the cylinder should be pretty warm to touch) before killing engine. Remove drain plug (on bottom of engine) and let all oil run out. Replace drain plug and remove filler plug on side of cases and add oil.