To install a clutch on a Yamaha Raptor 660, first, remove the left side cover by unscrewing the bolts and taking off the cover. Next, remove the clutch springs and plates, then replace them with the new clutch components, ensuring they're properly aligned. Reassemble the side cover, torque the bolts to the manufacturer's specifications, and check the clutch lever adjustment before testing. Always refer to the service manual for specific instructions and torque values.
The Yamaha Raptor 660 stock has 43hp.
The Yamaha Raptor 660 is a single cylinder.
To change the clutch on a 2002 Yamaha 660 Raptor, start by removing the clutch cover bolts and taking off the cover. Disconnect the clutch cable from the lever and remove the pressure plate by unscrewing the bolts. Take out the old clutch plates and replace them with new ones, ensuring they are properly aligned. Reassemble by reversing the steps, making sure to adjust the clutch cable for proper tension.
my raptor 660 will top out at about 80MPH
Raptor Forum has over 36 images of the 660 Raptor. The easiest method for finding the 660 Raptor is to use the box in the right hand corner of the site.
raptor 660 win
your one way starter clutch is blown out. same problem happened to me and raptors are highly know to break starter clutches. just buy an extreme raptor starter clutch kit.
660
To adjust the clutch cable on a Yamaha Raptor 660, first, locate the cable adjuster near the clutch lever. Loosen the lock nut and turn the adjuster to either increase or decrease tension; turning it clockwise tightens the cable, while counterclockwise loosens it. Ensure there is a slight gap between the lever and the perch when the clutch is pulled in. Finally, tighten the lock nut and test the clutch operation to confirm proper adjustment.
The Yamaha Raptor 660 is a motorcycle that was made by Yamaha between 2001 and 2006. One can purchase a second-hand Yamaha Raptor 660 at a used Yamaha dealer.
Yamaha sold the Raptor 660 from model year 2001 through 2005. They then redesigned the Raptor 660R in 2006 released it as a Raptor 700R.
The Raptor 660 has about 38 to 40 horsepower in the stock engine. This can be modified to increase the horsepower.