To change the clutch on a 2002 Yamaha 660 Raptor, start by removing the clutch cover bolts and taking off the cover. Disconnect the clutch cable from the lever and remove the pressure plate by unscrewing the bolts. Take out the old clutch plates and replace them with new ones, ensuring they are properly aligned. Reassemble by reversing the steps, making sure to adjust the clutch cable for proper tension.
The 2002 raptor 660 will go 100mph tops.
clean the carbs
The 2002 Yamaha Raptor 660 has a coolant capacity of approximately 2.5 liters (or about 2.6 quarts). It's important to use the recommended coolant type and maintain the appropriate levels for optimal engine performance and temperature regulation. Always check the owner's manual for specific guidelines related to coolant maintenance and replacement.
The ac compressor clutch is mounted on the front of the compressor and is a replaceable part. However depending on the complexity of the clutch change out it may be overall better to change the compressor and clutch together.
The motor oil capacity of the 2002 Yamaha Road Star is 5.3 quarts. However, it is recommended to use 4.3 quarts with a filter change or 3.9 quarts without a filter change.
you have to have the 2 holes that are in a line on the cam on the top center and the dot on the top gear top center and line the dot on the bottom gear up with the arrow above the gear to line the bottom gear up you have to have the clutch assembly off. just remember everything has to be top dead center
No, you do not have to .....
I think 2000-2002 are welded in.
No , the first model year of the Ford F-150 Raptor was 2010 , there was a 2002 Ford F-150 Lightning model made
i think it may be able to change like with a new flywheel The clutch cable is self adjusting ,do not try to adjust!!!
No , Ford did make the 2002 Ford F-150 Lightning ( the first model year of the Ford F-150 Raptor was 2010 )
i have fitted a new clutch, clutch fork, flywheel,clutch master & clutch slave cylinders the problem is i cannot get a pedal after bleeding the slave cyl,there is no air in the system & i still cannot get a good enough pedal help????