My 6hp Murray go kart goes about 20mph....your and f@#king dumb a@# you can go faster then that
i know you have to take the gas tank off.but i do't know anything else.hope that helps
Based on the type of system, there could be several lengths that would work.
if you look on the side of the engine cover it should say model number engine type and code...on a 6hp murray go kart with a Tec. 6hp it reads 196cc
The Mini Beast.
My 6hp Murray go kart goes about 20mph....your and f@#king dumb a@# you can go faster then that
The exhaust on most small engines is a standard pipe thread , that goes inside the exhaust port . You can go to any plumbing supply store and get your pipe .
i know you have to take the gas tank off.but i do't know anything else.hope that helps
I'm having same problem. What did you do?
Based on the type of system, there could be several lengths that would work.
Probably because the timing is off. It sounds like it is too far advanced or before top dead center. In other words firing the spark plug before the piston reachs the top of the stroke making it push the engine in reverse.
if you look on the side of the engine cover it should say model number engine type and code...on a 6hp murray go kart with a Tec. 6hp it reads 196cc
If this 'star' is what appears in Mario Kart Wii, called luma, then no. In fact, nothing goes round anyone in Mario Kart 7 without hacks or cheats!
Place woodblocks under the rear frame of the go-kart to raise it off the ground. Remove the belt guard by pulling out the cotter pin. Position the belt beside the clutches so that the arrow printed on the top is pointed toward the front of the kart. Wrap the belt around the clutch attached to the engine, then wrap the other end of the belt around the clutch. The belt should not make it completely on the second clutch. Rotate that second clutch while pushing the belt into position. It will slide on as the clutch rotates.
u hold r then move left to right till it goes orange ND there it goes
The Mini Beast.
Yoshi's egg kart