The maximum speed you can reach is also known as terminal velocity and this is the speed at which your mass is resisted by the air. Typically in a belly to earth body position, this is around 120mph. It takes around 10 seconds to reach this speed. The minimum exit height is 2500ft and would not reach this terminal velocity before they need to deploy their parachute. Most skydivers jump from a lot higher - between 10,000ft and 15,000ft. This gives them a freefall time of over 45 seconds and therefore they reach terminal velocity.
Once the parachute is open, the decent rate is less than 10mph, so no you do not hit the ground at maximum speed in answer to your question.
The maximum speed that a vessel will achieve relative to ground is its own maximum speed through water plus the speed of the the moving water downstream.
Without air friction, the horizontal component of the velocity will be constant. The vertical component of the velocity will be a maximum at the lowest point in its motion and at a minimum at the highest point in its motion. Therefore the minimum is at the highest point in its motion- Potential energy max Kinetic Energy min and the maximum is at its lowest point in the motion- KE is max PE min
The maximum speed of MCA is 10 MHz
The maximum speed of a 747 is Mach 0.92.
There are different speeds. They are called v-speeds: V1 takeoff decision speed V2 takeoff safety speed Va design maneuvering speed Vb design speed for maximum gust intensity Vc design cruise speed Vd design dive speed Vdf demonstration dive speed Vf design flap speed Vfe maximum flap-extended speed (top of white arc) Vh maximum speed in level flight with maximum continuous power Vle maximum landing-gear extended speed Vlo maximum landing-gear operating speed Vlof lift-off speed Vmca minimum control speed with critical engine out, out of ground effect (red radial line) Vmcg minimum control speed with critical engine out during takeoff run Vmo maximum operating speed Mmo maximum operating Mach number Vmu minimum unstick speed Vne never-exceed speed Vno maximum cruise speed (top of green arc) Vr rotation speed Vref reference speed for final approach, normally (1.3 x Vso) Vs stall speed Vso stall speed in landing configuration (bottom of white arc) Vsse minimum safe single-engine speed Vx best angle-of-climb speed Vxse best single-engine angle-of-climb speed Vy best rate-of-climb speed Vyse best single-engine rate-of-climb speed
cruise speed is when you're cruising, maximum speed is when your going hella fast
A lift accelerates to its maximum speed in 2 seconds. It then travels at this constant speed for some time before decelerating to rest at a point 40 m above the ground. If the total time taken is 12 seconds and the acceleration is twice the deceleration, find the distance over which the lift has moved at constant speed.
the maximum speed is around 89
The Titanic's maximum speed was 28 mph (44 kmh).
When it's at its maximum height its speed will be zero.
No, the average speed will always be between the minimum and maximum speeds.
Spindle speeds must not exceed maximum operating speed.