There are many different combinations of heads and shafts. I like Birne equipment a lot. The Clutch is a great head for every position. The swizzle or the swizzbeat are also great shafts i have the swizzbeat and it is great. It's light and has good grip for shooting. Unfortunately the grip can chip of unlike the swizzle, but the swizzle is 30 more dollars then the swizz beat.
To get a very tight Lacrosse head onto a shaft, spray both sides with a lubricant. WD-40 is a good lubricant for this procedure. Liquid Wrench will also work.
a warrior helix lacrosse head on a warrior kryptolyte shaft please add me to your saved sellers on eBay i have awesome deals on the top lacrosse gear
The shaft in lacrosse is the stick part. The butt is the rubber stopper on the end of the stick. The head is the plastic part which has the pocket. The shaft is the part of the stick where you hold it.
It shouldn't matter. Any head should fit on any shaft
the shaft itself is 60" long. With a head attached it is 6ft.
I would recommend that you do put a crank shaft head on a crank shaft. Putting any other type of head on a crank shaft could possibly break the head.
Wrap tape around the top of the shaft to however much more thicker you need. The best tape to use is electrical.
only if it is blacked out
Black, blue, and even red on red. _________ I'd also say that a silver or black shaft would look good with the red too.
Any head can be put on any shaft. All you have to do is put the bottom of the head in warm not boiling water, just warm tap water for a few minutes and it should slide rite on to your maverick shaft if it doesn't already.
no, just use muscle !
it shouldn't be. and no it will not work