You need to cut it to the right size to help it not get stuck.
the extension clutch
The clutch of a go kart is much the same as the clutch on a car. The clutch disengages the engine from the gearbox enabling the gear to be changed. Without a clutch gear changing would be difficult and may damage the gearbox.
Yes
To keep the cost down they use a centrifugal clutch off the engine.
Answer: You can eliminate much of your overheating by having the clutch adjusted properly. you cant
Make sure the clutch is completely disengaged when pushed, it may need to be adjusted, it sounds like the clutch is dragging. get a better go kart or add a raidiatoraor even use some overheating additive...............or maybe the go kart has too much weight in it.... those clutches are supposed to slip are they?
its is a cluch
if you already have a clutch on the 140cc GX just use the chain direct to axel..
to put the clutch on omn side of the motor theres a crak and you to the clucth on there then put the keyway in the slot or you dont have to if the clucth has a biuld in keyway
It depends on the type of kart. Rental karts - pulling cord Clutch karts - pulling cord or power button Direct drive karts - pushing
spin the rear wheels and use a heat gun on the chain
Place woodblocks under the rear frame of the go-kart to raise it off the ground. Remove the belt guard by pulling out the cotter pin. Position the belt beside the clutches so that the arrow printed on the top is pointed toward the front of the kart. Wrap the belt around the clutch attached to the engine, then wrap the other end of the belt around the clutch. The belt should not make it completely on the second clutch. Rotate that second clutch while pushing the belt into position. It will slide on as the clutch rotates.