0
What else can I help you with?
What outer edge of a cup or plate?
The outer edge of a cup or plate is called the rim. It serves as a boundary between the content inside the cup or plate and the external environment. The rim also provides support for holding and lifting the cup or plate.
Is the distance in fastpitch softball measured from the pitching rubber to the front of home plate or the back of home plate?
According to the official rule book, the bases are located inside the diamond.If you were standing on the pitcher's mound, then no matter which base you look at, the measurements would be behindthe bases, because the back corners of each base is what touches the measured diamond.Home plate is measured from the point (the part that points to the catcher) to the far right corner of first base (which touches the foul line). First base to second base is measured from the foul line to the center field corner of second base, etc.
Is the 60 foot 6 inch distance from mound to plate measured at the front of the plate or the apex?
The distance is measured from the back of home plate to the hill. Hope that helps Answer More accurately, the distance is measured from where the first and third base lines meet (the apex of the plate) to the front edge of the pitcher's plate.
What part of the base is measured from when measuring first base to second base?
It is 90 feet from the tip of home plate to the front edge of 1B and 3B. The 90-foot distance from 1B or 3B to 2B is measured from the foul line to the center of the 2B bag.
What is the distance from first base to home plate in baseball?
Do the math by using pythagoream therom. make a triangle using homeplate first base and second base with the bases being 90 ft apart. the distance from home plate to 2nd base comes out to 127ft 4in.
How do you place a napkin on side of plate - cut edge to outside or toward plate?
The edge should face away from the plate.
How is the distance measured from home plate to the pitching mound in fastpitch softball?
infeet it is 43 feet from home to the pitching mound
A manufacturing company is producing plates with a radius of 6 inches. They plan to put a gold edge on each plate . Determine how much gold edging will they need per plate?
determine how wide edge will be and thickness need'd for each plate first
When was Inside Edge created?
Inside Edge was created in 1984.
How much of the plate does the ball have to cross to be an inside or outside strike?
even if the smallest bit of the ball crosses over the edge of the plate, it is to be called a strike as long as it is still within the strike zone
Are the Appalachian mountains on an active plate edge?
No. There is no such thing as a passive plate edge. They are near a passive continental margin.
Do the Andes and Appalachian Mountains lie on the same type of plate edge?
No, the Andes are near a subduction zone type plate edge but the Appalachian Mountains are not near any plate edge of any kind.
