You need to switch off the stereo and then you can use the buttons next to the clock to change the time. this also changes the time on the stereo.
Access your time and date change function in the COMAND function part of your stereo. When you turn on the stereo there will be a setting button on the bottom of the screen. Scroll down to the setting and enter on it. You will see time and date, scroll over to it and click on it. Change your time and date if necessary and you can even change whether you want it shown in military time or standard time.
My 2004 vw Passat has Monsoon stereo. It works from time to time and when isn't working, there is a "check" on the stereo display. How do I fix this problem?
There should be a button on the dash board by the stereo that says "CLK" you need to hold that button down and manually turn the tune knob to change the time. If that does not work try the seek scan button while holding down CLK to change the time.
Push on the clock display button until time starts flashing. Let off of the button. The numbers 5&6 button have a small h and m on them for hour and minutes. Push these buttons one at a time until you get the minutes and hour you desire. Don't hold the button down constantly. You have to punch them until you get the right time.
Leaving a stereo system all the time will likely cause no issues. Most modern stereo systems are 100 percent solid state and are not overly affected by heat.
It is scored by your time. The lower it is, the closer you are to winning.
No stereo skyline are not in big time rush their are only 4 members Kendal (my favorite) Logan,Carlos and James.
if your stereo is no longer illuminated, sorry for your luck. these bulbs are inside the radio unit, and are soldered in place, if you are familiar with how to solder, you might be able to disassemble the radio, and replace them, but its probably less frustrating and time consuming to replace the stereo, with a new or aftermarket unit.
Depending on the type of stereo is in the truck, I have a AM FM Stereo, CD, Tape system. At the lower left hand corner of the unit there is two little buttons one labled with an H the other with an M. Pressing either one of them for more than 5 seconds will start the time adjust sequence.
You complete the course in the smallest amount of time.
The little hour and minute buttons are under the larger display button at the bottom left corner of your stereo. Press and hold one of these buttons and your time will change.