answersLogoWhite

0

Remove the slotted nut, needs a special tool or some can get it off with a punch and a hammer. Trying to put the case with seal on over the slotted nut destroyes the seal unfortunatly

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How to install a polaris ATV drive belt?

remove clutch cover. remove old belt. install new belt.


How do you remove a starter form polaris magnum 330?

Remove the cables from the starter. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.


How do you replace a stator on a polaris 90?

Remove the starter cables. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.


How do you replace the rearend gears on a Polaris 325 4x4 the rear drive shaft turns but wont engauge?

To replace the rearend gear on the Polaris 325 You have to jack it up and remove the eight bolts that holds the rear end cover on. After you remove it you simply have to pull the old gear out and install the new one.


How do you get to the starter on a Polaris xPlorer?

To remove the started on a Polaris 300 Explorer ATV first open the hood. Locate the started which will be up against the wall near the driver's side and remove the screws. You can now install a new started.


How do you install a starter for a polaris trail boss 325?

To install a starter for a Polaris Trail Boss 325, first disconnect the battery to ensure safety. Remove the old starter by unbolting it from the engine and disconnecting the electrical connections. Position the new starter in place, secure it with bolts, and reconnect the electrical wires. Finally, reconnect the battery and test the starter to ensure it functions properly.


How do you replace the starter on a 1991 Ford Probe?

Disconnect - Battery cable Raise and safely secure vehicle Remove 2 mountig bolts Remove wiring harness Remove outer tie rod end remove cotter pin loosen slotted bolt Rap housing sharply w/hammer to release (should pop-up) Remove slotted nut twist and remove starter


What goes through the filtering of a slotted spoon?

A slotted spoon is typically used to separate solids from liquids. When using a slotted spoon, the liquid drains through the slots while the solids are retained in the spoon, allowing you to easily separate out and remove the desired components from the mixture.


How do you remove the governer from a polaris predator 90?

Don't do it, it is there for a reason.


How do you remove radio from BMW 530d 2002?

How do I remove radio from 2000 BMW 530D SE have found slotted screw behind on/off knob


How do you start a rolled Polaris Indy 340?

remove the spark plugs and crank it without starting it and that should clear out the cylinders then clean the plugs with carb cleaner and install them .then start it . it may smoke for a few minutes.


How do you Repair a window counterbalance?

remove the trim that holds the window in, on the side of window frame there should be a plate, behind this is the counter weight,