Want this question answered?
Be notified when an answer is posted
If its a manual seat there is a lever in front of the seat underneath you pull up. If its power there will be a oval shaped lever that you push forward. You can also use that lever to adjust up, down, etc. The lever will be on the left side of seat, towards the bottom on the plastic trim.
To adjust the seat height on a bike, locate the quick-release lever or bolt on the seat post. Loosen the lever or bolt, raise or lower the seat to the desired height, and then tighten the lever or bolt securely. Make sure the seat is at a height where your legs can fully extend when pedaling.
Yes, the seat does come out. There should be a lever on the passenger side of the seat. You lift the lever and the seat will fold down. There is a metal bar right close to the floor in the middle of the seat in the back. Lift up that lever and the seat will lift up rotating forward and then you just lift the seat straight up to remove it.
A toilet seat cover is a lever.
There is a small lever by the door at the top of the back seat. Flip the lever and the seat should fold down.
There is a lever on the left side of the bench seat. Pull up on the lever while pushing down on the top half of the bench seat.
There are two levers under the driver's seat of the 1992 Cabriolet. One lever moves the seat back and forth and the other offers a tilt option.
release the bar and pull. There is a small lever next to each back headrest. Pull the lever UP and the seat will release. Then pull the seat forward.
well it is a lever bacause a lever is used to adjust things
To adjust the height of your bike seat, locate the quick-release lever or bolt on the seat post. Loosen the lever or bolt, then raise or lower the seat to your desired height. Tighten the lever or bolt securely to hold the seat in place. Test the height by sitting on the bike and adjusting as needed for comfort and proper leg extension while pedaling.
To remove the back from a Graco booster seat, locate the release button or lever on the back of the seat. Press or pull the button/lever while simultaneously lifting the back of the seat upwards. This should detach the back from the base of the booster seat.
From the back of the seat, at the lower right corner, there is a lever that should be pressed to the left to release the seat and allow it to fold down. The same lever is used, in the same manner, to open the seat.