Wiki User
∙ 15y agoLOW PRESSURE HOSE:
Yes, a low pressure hose. A high pressure hose has a very small diameter opening since it is just used to measure pressure and it is not performing any work. A low pressure hose is used to perform work and has a larger diameter opening so air can move through it.
Wiki User
∙ 15y agoThe empty weight of a 100 cubic foot steel SCUBA tank is approximately 33lbs.
about 32 pounds empty
a scuba tank is very thick, and so it wont be used if empty the valve remains to be closed, not allowing any air to excape, disallowing to be crushed. if the air cant leave the tank it wont crush.
The pressure will increase
Equalising, to stop bleeding out of the ears. Whole scuba suits to ease mobility.
scuba divers use pressure meter because the deeper down you go the more pressure builds upAdditiona depth gauge or a dive computer
No, only when it is released into the atmosphere at the ambient pressure.
The partial pressure of oxygen can be calculated by multiplying the percentage of oxygen in the air by the total pressure. In this case, 20 percent of 6.3 ATM is 1.26 ATM. Therefore, the scuba diver is breathing oxygen at a partial pressure of 1.26 ATM.
scuba tanks are under a lot of pressure, when particles are heated up, they expand and the pressure builds. if the pressure builds to the point of rupture then shrapnel will mess your car up... and if your in it, it will mess you up very bad!
Think on it a bit closer: -- The expansion is happening in the high-pressure reservoir, as some of the air leaves and the rest expands to fill the volume. So you'd expect the supply tank to cool as it empties. -- The compression is happening in the SCUBA tank, where you're continuously stuffing more and more air into the same volume. So you expect the SCUBA tank to warm as it fills.
One of the major advantage of personal submersibles over scuba gear is you can't feel the changing pressure while ascending and descending.
the amount of air in the tank per square inch. (p.s.i.)Improve answerPounds per Square Inch - so the amount of pressure exerted on the tank by the air under pressure in the cylinder of the scuba diver. The more pressure, the more compressed the air so the greater the volume of air compressed within the cylinder.for more on scuba diving, including equipment see the related link: