0
Add your answer:
Earn +20 pts
What happened when you put glove on your hand and took it off after 5 minutes?
One hand will be warmer thn the other.
Which hand did Freddy Krueger wear his glove?
When he was still alive Freddy made the glove himself. He took a gardening glove and fashioned sharp knives to the end of each finger. It was crude but suited him in his sociopathic ways.
Where do you find the hood release on a 1996 tracker?
the hood release is found in the glove box on the right hand side it took me almost a hour to find it
What would happen if someone had cyanide?
If you took cyanide, then you would most likely die within minutes.
You are on 4mg of suboxone and want to know what would happen if you took one hydrocoapap5-500mg?
Absolutely nothing at all would happen the the buprenorphine will block the tiny amount of hydrocodone and you would feel nothing. Even if you took a hand full the same day as you took suboxone, it would block the hydrocodone.
Where is blower motor located on 1995 Toyota Tacoma pickup and is it hard to replace myself?
underneath the dash under the glove box area and only held on by 3 star screws took me about 3 minutes to change it
How do you put the glove box back after removing it from a Toyota Highlander?
In the reverse method of the way you took it out.
How many minutes did it take for the lusitania to sink?
It took 2 minutes
What does ordeal by fire mean?
It is when a knight fails a tournament and he gets punished and he has to carry a metal bar and it is very hot and he walks with it in his hand for 30 minutes/seconds and he ends up with blisters and his skin of his hand is took off and then he is all bandaged up for a week and he has to have his hand healed by a week or he is dead.
Why are his glove wet?
because they might have to go and stand in the rain and have to guard the palace, building or something.
You took a equate pregnancy test after 3 minutes there was a very faint positive sign then you took another pregnancy test of a different brand and it was negative what does that mean?
the same thing happen to me ...very confusing...maybe the equate brand is more sensitive than the other
How do you replace the blower motor resistor on a jeep 2000 Cherokee?
I just replaced mine and it took 30 minutes and the part was $35 (from Jeep dealer). Start by removing 3 philips screws that hold glove box in place (on bottom edge of glove box). Once glove box is out you can see the resistor but I couldn't get to it without removing the black panel under the glove box. ...So remove the bolt/screw that hold the little light that lights up floor by passengers feet. Next, remove 4 or 5 screws that hold the black plastic panel that is under the glove box (I removed the 2 screws toward firewall and a couple toward the seat and left the one on the right hand side screwed in because it was hard to reach) ... then remove 2 screws holding the resistor. Screw in new resistor. THEN TURN ON JEEP AND CHECK TO MAKE SURE IT WORKS. Now just reverse the process and put the plastic panel and glove box back. That's All Folks!
