0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is negro knucle ball in ref to golf?
Its a Niekro ball. As in a knuckle ball. The brothers Joe and Phil Niekro both threw knuckle balls.
How do you knuckle a soccer ball?
By the tip of the boot.
Will a knuckle ball slow down your fastball?
Yes
How the knuckle joint is made?
Do you mean the ball joint in an automotive that is connected to the knuckle? Please write to 2459473@gmail.com for answer.
How does one remove the ball joint from the knuckle on a 1998 corolla?
There is a striking surface (flattened or machined area) on the knuckle on the outer diameter of the ball joint contact surface. Hit the striking surface with a large ball peen hammer (or equivalent) with the retaining nut slightly loosened. After the ball joint has "let go" you can remove the nut and the knuckle.
What are Jennie Finch's pitches?
Fastball, curve ball, drop ball, rise ball, screw ball, knuckle ball, change up
Who invented the knuckle ball?
Doubtlessly some baseball pitcher.
What is ball joint?
In an automobile, a ball joint is a spherical bearing that connects the control arm to the steering knuckle.
What does knuckle ball mean?
A knuckle ball is thrown when a pitcher hold the ball, not with his fingers fully extended, but bent such that only the "knuckle" of the fingers is touching the ball when released. When done right -- and it is not an easy pitch to throw correctly -- the ball will have very little spin. As such, the ball can go just about anywhere before it reaches the plate, depending on how the wind is blowing. When a good knuckleball pitcher is throwing well, batters will be flaying at the ball almost helplessly, as even the pitcher has no idea what it will do as it heads towards the catcher.
How do you replace the lower ball joint on a 2000 Lincoln ls?
It must be replaced as an assembly with the entire steering knuckle. If you check ebay, there might be just the ball joint for sale, but it will need to be pressed into your old steering knuckle.
How do you replace all ball joints on a 01 F250 2wd with twin I beam suspension?
First, remove the wheel and brakes and then steering knuckle from each side. Then, for each knuckle, use special tool to press each ball joint out of the knuckle. Use same tool to press new ball joint into place. Reassemble. Or, if you don't know how to do any of that, go to a good mechanic.
How do you get in the major leagues?
be a good ball player enter the draft and get drafted
