Q: How do you deactivate the hourly chime on NFL scoreboard clock?

Write your answer...

Submit

Still have questions?

Related questions

I have the 750Li In i-drive go to settings/clock and de-select memo and you're done.

Check the back for kinks

Just bought a used Daniel Dakota Westminister wall clock and it does not chime.

To calibrate the Daniel Dakota Westminster Chime clock, first wind the clock fully. Then adjust the time to 5 minutes before the desired time and let the clock chime. You can fine-tune the clock by adjusting the minute hand to the exact time when the chime sequence ends. Repeat as needed until the chime matches the correct time.

I have a Walthram 31 day chime clock and on of the weights fell to the bottom of the clock. How do I fix it and why did it fall?

It depends on the clock; None of my clocks chime even once. A clock that rings the quarter hours (like the clock in the Palace of Westminster - aka, Big Ben) would chime 96 times per 24 hours. Some clocks only chime on the hours, which would be 24 chimes/day.

4 seconds

You cannot turn off the chimes on this clock

The Seiko QXH-series can chime on the hour, but you'll have to enable it first.

It may just be to old. You can still use it as decortion.

12 Chimes.Assuming that a "chime" is the full sound range from start to finish, the clock will chime 10x in 8 seconds. It will chime 2.5x in 2 seconds, and assuming that a chime is the full sound length from start to finish, .5 chime does not equal 1 chime.Therefore 10+2=12 ChimesThe above answer is only right if we assume that at 0 seconds the clock chimes 0 times.If we instead assume a starting signal - meaning the clock chimes for the first time at 0 seconds - then it would be reasonable that each consecutive chime would happen one second later. Therefore after 10 seconds the clock would have chimed 11 times.One starting signal and 10 second chimes.

It takes 1.25 seconds for each chime so it will chime 72.5 times in 58 seconds