It depends on the gun and adapter but usually you have to insert it seal first into the area where the pin is (there will be an oring there). Usually you have to screw something in to pierce the seal, but there could be a lever or other device instead. The other method is you unscrew the charger from the gun, drop the co2 cartridge in, and screw it back on.
The top of a CO2 canister isn't very thick. It will take about a half a pound of pressure to break through the top.
one day
A 9oz CO2 canister typically provides around 800-900 shots in paintball guns, depending on the marker's efficiency and settings. The thrust produced by a CO2 canister is not commonly measured in thrust units like Newtons or pounds-force, as it is more relevant to measure its capacity in terms of shots fired.
A gram of CO2 has more molecules than a gram of H2 because CO2 has more atoms per molecule (three atoms in CO2 compared to two in H2). Thus, CO2 will have a higher total number of molecules per gram.
To calculate the amount of CO2 produced when burning 34.3 grams of C3H8 (propane), you need to balance the chemical equation for the combustion of C3H8. Since each mole of C3H8 produces 3 moles of CO2, you first convert 34.3 grams of C3H8 to moles, calculate the moles of CO2 produced, and then convert that to grams of CO2.
To start a co2 dragster, you just simply shoot the co2 canister and then the co2 dragster will go.
At 70 degrees F, CO2 obtains a gas pressure of 852.8 psi when confined in a vessel
You can recycle it.
When using a CO2 canister for your bike, it is important to follow these safety precautions: Wear protective gloves to prevent frostbite from the cold temperature of the canister. Make sure the canister is securely attached to the inflator device before use. Do not puncture or expose the canister to high temperatures, as it can explode. Point the inflator away from your face and body when releasing the CO2 gas. After use, properly dispose of the canister in a recycling facility.
A typical paintball canister contains compressed air or CO2 at pressures of around 3,000 to 4,500 psi. The amount of CO2 in the canister can vary depending on the size and pressure it is filled to, but a standard 20 oz canister typically contains around 14-16 oz of CO2.
All Co2/HPA tanks will fit any marker. Co2 cartridges will not.
unscrew the tank, this will vent any co2 that is in the marker out the asa