About 8 PSI
7.5 to 8.5 psi
A concrete strength of 3500 PSI should be just right for a basketball court.
Oh, dude, you're asking about the PSI in a basketball explosion point? Well, technically, the pressure at the explosion point of a basketball can vary depending on factors like the material and condition of the ball, but it's usually around 8-10 psi. So, like, be careful out there on the court, or you might witness a basketball blowout!
Assuming standard atmospheric pressure of 14.7 psi, the pressure difference in the basketball is 5.3 psi. To estimate the volume of air in the basketball, you'd need the basketball's size, as well as assumptions about temperature and ideal gas behavior. This volume would be significantly larger in standard conditions than when pressurized.
You will need a gauge and you would check the Pressure on the low side port. Take the PSI reading when the compressor is on and the clutch is engaged. The correct PSI is determined by the current ambient temperature and you can find a PSI chart on the website listed below.
psi on a 2000 Chevy truck, place the key in the on position the fuel pressure should be between 50- 60 psi....The General Motors test for this is the pressure should NOT drop more than 6-8 psi during the first 10 secounds, if it does check you fuel lines for leakes at the filter and check the check ball in the fuel system
It is when you check the ball you check it to there shoe
Check pressure At idle 13-20 psi With ignition on and not running 23-31 psi
Check the label on the driver's door jamb, should be around 32 psi.Check the label on the driver's door jamb, should be around 32 psi.
Yes, in 2002 they proved that basketballs do fly with the right amount of pressure, density, and weight.
A regulation basketball is inflated to a pressure of 7.5 to 8.5 pounds per square inch (psi), which is the standard air pressure for most basketballs.