0
If a soccer ball is in the air when the timer runs out is the game over immediately or when the ball touches the ground?
Timekeeping in football (soccer) isn't an exact science. There is no timer as such, the time added by the referee is his guideline, he may go slightly over it to allow for other stoppages. The referee will usually end the game when there is no advance of attack to either side, that is usually when the ball is in the middle of the pitch, or when there is no possible way one team will overturn the deficit. You will notice the vast majority of games end just after the goalkeeper takes a goal kick.
What else can I help you with?
What is a one timer in soccer?
A one timer in soccer is where if someone passes you a ball and you hit it with only one touch into the net.
Why a one timer in hockey called a one timer?
the puck only touches the stick one time, instead of at least twice during a pass....
Should in ground pool filtration be on a timer?
Yes it is best to set filtration to a timer.
What is it called when you shoot the puck immediately after you receive a pass?
a "one timer"
Why does a 555 timer blow up?
Check for shorts to ground from your output pin
What are the four timers used in TCP?
Connection establishment timer, persist timer, keepalive timer, retransmission timer
Is timer a short vowel?
The i in timer is a long vowel and the e in timer has a short vowel.
Is there a timer on the blackberry curve?
it depends on if you mean a camera timer or an overall timer.. if an overall timer then yes. if a camera timer then no, none of the blackberry's have a timer for your camera. but if you go on app world and type in "nux shoot" you will get one, it is completely free and great.
What would happened if you wired a 240v ballast and a 120 v ballast into a heavy duty timer?
The timer has to be multi-pole. The ballast must be connected to the load contacts of the timer. If the timer is a 120 Volt timer, the timer has to run on a 120V. circuit. Loads are loads, and as long as you have a multi-load timer you can hook up whatever you want. If the timer only works on a shared power source (load shares the timer supply) you will need to use a contactor on the load side or the timer.
How can I test a dryer timer to ensure it is functioning properly?
To test a dryer timer, you can use a multimeter to check for continuity in the timer contacts. Set the multimeter to the ohms setting and touch the probes to the timer contacts. If there is continuity, the timer is functioning properly. If not, the timer may need to be replaced.
How do you implement a WD timer in software?
wd timer
How many digit in a timer?
There are eight bits in a timer.
