answersLogoWhite

0

its just puting the other foot in front of the one you are use to you just switch feeting position.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the kill switch on the craftsman riding lawn mower?

The engine kill switch is under the seat.


How do you disable the reverse switch on a snapper riding mower?

To disable the reverse switch on a Snapper riding mower, first, locate the switch, usually found near the seat or on the mower's control panel. You can either disconnect the wiring harness from the switch or remove the switch itself. If you prefer a temporary solution, you can tape or cover the switch to prevent it from engaging. Always refer to the owner's manual for specific instructions and safety precautions.


Where is the light switch for the headlights on a craftsman riding mower?

Mine is built into the ignition switch. After you crank it turn the key back to the left slightly.


Riding lawn mower diagram of a starter solenoid?

Like any power switch you have Power in, Ground, Switched Power out and the Switch Terminal.


Can keeping seat switch push in on saber riding lawn mower drain the battery?

no


What is a slender rod or stick used for whipping?

Can be either a "switch" or possibly a riding crop.


How do you change from a groom to a riding instructer on Howrse?

To become a riding instructor, you must pass Riding Level 2, once you have 10 days seniority.Then, when your current contract ends, go to your Job page, and click Switch Job. Then select "Become Riding Instructor" and go from there. =)


What is the difference in snowboarding between board sliding a boxrail and riding off normal or board sliding a box and riding off switch?

boardslide back to regular/ boardslide to fakie


Why does torro riding mower stall when put into gear?

This is usually caused by a faulty seat safety switch.


How do you check switch on riding lawn mower?

Unhook wires from switch make sure you mark them so you can put them back on properly. Put a battery powered test light on terminals in and out of switch try switch if the light goes on and off when you move the switch then it is working and you have other problems.


How can you put a push start button and toggle switch to run your riding mower?

Yes, you can replace the key with a switch/button combination. The key is mainly there as a anti-theft feature.


How do you know if the starter on your riding lawn mower is defective?

Bypass the switch with a jumper & see if you can bump it with a hot wire.