0
There are three basic types of ice skates: hockey skates, figure skates, and speed skates.
Ice skates are constructed of leather, nylon, plastic, steel, and various other synthetic materials
Knit nylon and molded plastic are commonly used for hockey and speed skates.
The leather and nylon are specially treated for water-resistance.
Blades are generally made of tempered steel and coated with a high-quality chrome, though some blade manufacturers may add titanium to the metal.
4 The boot is shaped by placing it on a last, which is a plastic foot form corresponding to a particular shoe size and width.
First an insole is tacked onto the last.
Then the boot is pulled tight, by hand, over the bottom of the last.
A worker then makes sure that all wrinkles are eliminated, working from the arch to the heel then from the arch to the toe.
Tacks or cement adhere the arch, heel, and toe to the insole.
The boot, still stretched over the last, is placed into a drying chamber.
Heat is applied to set the boot to the length and width of the last.
The boot is placed upside down on a peg under an electric grinder to remove the leather finish from the boot bottom.
The grinding process causes a crevice to form across the middle of the boot bottom where the foot's natural arch occurs.
This crevice is packed with a synthetic filler and an 18-gauge spring-steel arch support shank.
A leather or rubber sole is then attached to the boot with a urethane base cement.
The heel (where applicable) is constructed by gluing square stacks of leather or water-repellent fiberboard on top of each other.
The heel is glued onto the boot and then six to ten long nails are driven through the heel, outsole, and insole.
Finally, the heel is trimmed and smoothed.
The sole and heel plates of the blade are lined up with the sole and heel area of the boot bottom.
A worker then screws the blade onto the boot using a high-speed drill on a foot-powered press.
Only a few of the screws are inserted into the boot; the remainder are packaged with the ice skates. This allows the skater to adjust the blade as necessary before the remaining screws are inserted and tightened.
However, the blades of skates fitted with rubber soles are permanently attached with rivets.
The completed skate is hand-polished and sprayed with a solution to make it shine. Laces are threaded through the eyelets.
The skates are then boxed for shipping.
Add your answer:
Earn +20 pts
How do you make an ice skating rink in your backyard?
a hose
Where is ice skating played?
in an ice rink
What does a la patinoire mean in English?
skating No, it means at the ice-skating rink (skating is le patinage) It actually means ice rink
Where is figure skating done at?
an ice rink
Is there an ice skating rink in Chicago?
Yes.
What does je vais a la patinoire?
I'm going to the skating rink (probably the ice skating rink, but not necessarily)
Where is the court for ice skating?
Hampton Court Ice Rink
Does a carnival cruise ship have an ice skating rink on it?
No because the ships lengths are too short and the beam is too short for an ice skating rink
Golf is to course as ice skating is to?
rink
What is an enclosed sheet of ice usually artificial for skating?
An ice rink, usually affectionately referred to as 'the rink'
What are the strength of having a skating rink?
There are a variety of activities that you can do on a skating rink. These activities will all make you a stronger, healthier person. You would also have a huge advantage over others if you actually owned your own skating rink... You could have unlimited ice time.
Are puddles of water on the ice at an indoor ice skating rink a danger or is this acceptable?
Water on the ice at an indoor ice skating rink would not be acceptable, and should be reported to the management immediately as a safety hazard. And do not skate on that rink until the problem is fixed.
