0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What should you do when operation a boat in large waves and high wind?
head into the waves at a slight angle and reduce speed
What is approach Angle in Metal Cutting?
Approach angle in metal cutting refers to the angle formed between the cutting edge of the tool and the workpiece surface. It determines how the tool engages with the material during cutting and has an impact on cutting forces, tool life, and surface finish. A proper approach angle is important for efficient and effective metal cutting operations.
Are the throttle plates supposed to be flat or at an angle in the idle position on a holley 650 doublepumper?
A slight angle.
How do you sharpen a cutting tool for a lathe?
You should know the angle of the cutting tool. You can use emery sharp cutting tool.
What is side cutting edge angle in single point cutting tool?
Indicates that the plane which forms the flank has been ground back at an angle to the side of the shank
What is the best reason in a proof for an angle being a right angle?
being a nice and helpful good angle.
Wood chisel what angle to sharpen?
The standard sharpening angle, the angle at the cutting tip, is 30 degrees. The backing angle, the bevelled part of the chisel back of the cutting tip, is always less than the sharpening angle and is usually around 20 degrees.
How is math used in cutting hair?
Math is used in cutting hair, because of the angle of the cut.
What direction do you flip a skateboard during a kickflip?
put your foot just under the bolts, and angle it pointing towards the nose[not completelt forward, slight angle.] pop just like an ollie, and flick off right where the concave begins[ curve of your board towards the nose] hope this helps.
How do you do angle parking?
You can perform angle parking by cutting the steering wheel at a sharp angle and then pulling into a space. Keep the wheel cut to achieve an angle.
What is end cutting edge angle in single point cutting tool?
It is the angle between face of the tool and a plane perpendicular to the side of the shank.It varies from 5 to 15 degrees.
What is a homograph for lean at an angle and a helpful piece of advice?
The homograph for "lean at an angle" is tilt. As a helpful piece of advice, tilt can also refer to offering a suggestion or recommendation to someone.
