answersLogoWhite

0

When a left-handed welder is making a cut with a hand torch, the torch should be braced with the left hand while the right hand operates the torch. This positioning allows for better control and stability during the cutting process. Additionally, the left hand can provide support and help guide the cut accurately. Proper bracing is essential to maintain safety and achieve a clean cut.

User Avatar

AnswerBot

4w ago

What else can I help you with?

Related Questions

What school should a welder go to?

A Welder should go to Harverd are the sort


Can you weld map welder id numbers?

probably a editing mistake; question should be: can you read map welder id numbers?


What is the principle of electric welding?

the basic principle of welding is 1. first we have some broken material 2. a welder 3. welder should know how to weld


What is the pay rate for experieced welder in NJ?

What is the yearly wage of a welder? What is the yearly wage of a welder? What is the yearly wage of a welder?


What is the 60 Hz on a welder with the listed input as 208 230 volt single phase 60Hz?

60 Hertz is the frequency that the welder should be connected to, to work as it is designed to.


Can a welder be promoted?

Pipe welder?


How do you unthaw frozen water main pipes under a driveway?

first you have to get someone with a portable welder commerical grade, attach the leads to the pipe , the welder guy should know how to do this , turn on the welder and the current will heat the pipe enough to thaw the pipe,


What should the welder watch if the view of the weld is obstructed by the shielding gas nozzle?

Porosity


How much money should a fine art welder make?

37 cents an hour


Is TIG Welder is also considered as Co2 welder?

No , although Co2 may be used , along with other gasses , a welder using this process is not considered a Co2 welder . TIG stands for tungsten Inert Gas , so the welder is considered / called a TIG Welder.


Will a 800 watt generator have enough power to operate a 90 amp welder?

No, unless you can set it low and can be assured that it wont use more than say 4000watts, the welder might momentarily use more power than what you set it to, it should not wreck the welder i would imagine unless it is a fancy mig welder or something, set the welder low you should be fine but for high end use she should be firing out 8 or 9kw so keep it low if you must.


What does a certified welder make an hour?

In Baton Rouge, Louisiana the average certified welder makes between $20-$30 an hour. Now it might be a little different where you're from, but it should be similar to these