what is the string length of a Mathew Mission compound bow
The cable rod and slide is used to allow clearance of the arrow so that it does not damage the fletches.
No, it's not better for a microphone, but it's better for a long cable connection without treble loss. Scroll down to related links and look at "Cable Length, Cable Capacitance, and Treble Loss".
AnswerThe word "cord" refers to a what is usually called a cable. A 1/4" cable can be used to connect your electric guitar to an amplifier. The word "chord" refers to a group of notes played together.I think you mean "chord". The combination of atleast 2 strings played together makes a chord.
check out the bass that the guy in disturbed uses by a brand called traben , through a cheap guitar cable and a microcube amp it blew me away with the heaviness of it.
How do you change the choke cable on a 2000 Honda Rancher?
Bear says bow string length is 86.125in & buss cable length 31in
String 82 Cable 39 3/8
String is 98.5 and cable is 41.5 It varies by draw length, this is for 28" draw
I believe string length and cable length aren't 2 different things I can't seem to get a answer
35, says it on the factory sticker on the lower limb.
Mathew Feather lite String is 94 15/16 Cable is 40 3/16
No, you cannot. The shorter connection will not fit the string/cable. Even if it did, the tension could damage the bow.
Cable weight is typically measured in pounds per thousand feet (lb/ft) or kilograms per meter (kg/m). This measurement gives an indication of the overall weight of the cable per unit length. To determine the weight of a specific length of cable, you can multiply the weight per unit length by the total length of the cable in the desired units (feet or meters).
Simple do a search on " USB cable" find the correct length you need and order it on line of go to a store that sells computers . to get the correct length, run an extension cord, string or wire from the beginning to the end , then mark it pull it out and then measure it ! bingo you are in business .......
1) Disconnect the antenna lead from the back of the radio 2) Tie a string around the end of the antenna wire that you just removed (make sure it is at least 4-5 feet in length 3) Remove the screws from the antenna mast mounting and pull out the antenna and cable with the string attached to it 4) Untie the string from around the end of the old cable and tie it to the end of the new cable 5) feed the end of the new cable into the mast mounting and, using the string inside the car, pull the new cable down through the pillar 6) Un-tie the string and plug the end of the cable into the radio 7) Re-install the antenna mount with the screws and tighten securely
You can select the cable length in the option box.
A cable length is a unit of measurement equal to one tenth of a nautical mile.