Indian Premier League match consist of 40 overs in which each team plays 20 overs .It is smallest format of cricket match.It is also known as T20.
A team's run rate (RR) is their total number of runs divided by overs faced. As an over is made up of six balls, each ball counts for 1/6 of an over for the purposes of calculating the net run rate, despite being normally written in cricket's notation as .1 of an over.So if a team scores 250 runs off 50 overs then their runrate is ??. If they got that same score off 47.5 overs, their RR would be ??The concept of net run rate involves taking the opponents' final run rate away from the team's run rate. The only complication is that if a team is bowled out, it is not the balls faced which their score is divided by; instead the full quota of overs is used (e.g. 50 overs for a one day international and 20 overs for a Twenty20 match).Usually, runs and overs bowled are summed together throughout a season to compare teams in a league table
It depends on the variant of cricket being played.There is generally no limit to a bowler in First-class cricket since is there is no hard-set limit to the number of overs that will be bowled in a given innings.For limited-overs matches, the general rule of thumb is that no one bowler can bowl more than 20% of the given overs in an innings. In a One Day International (ODI) match, for example, a bowler can bowl a maximum of 10 overs (less if a game is shortened by weather). Accordingly, Twenty20 limits a bowler to four overs.There is, however, one important rule for a bowler that can cut short his innings. A bowler is not supposed to run through the pitch's protected zone (generally the zone directly between the wickets) while following-through on his delivery. If caught doing so three times, he is prohibited from bowling for the rest of the innings.
A batting team has two 'resources' that it can use to produce runs. These are Wickets in hand, and Balls yet to be bowled. There is a table that will tell you what percentage of your resources you have left, given the number of wickets in hand, and the number of balls left to be bowled. When weather or light prevents some of the overs being played, then the team will have lost some resources. This change in the team's resources will be a percentage. Their target is reduced by this percentage. "http://en.wikipedia.org/wiki/Duckworth-Lewis_method" "http://news.bbc.co.uk/sport2/hi/cricket/rules_and_equipment/4184006.stm" - The example on this website explains it really well. hi..ya it is right
There will be two innings of 20 overs each with 2 breaks of 2.5 minutes each during each innings. There will be a 10 min break between innings. Usually it takes 1.5 hours on an average per side to finish their batting and the whole match usually ends in around 3 hours.
A baller can ball unlimited overs in a test match. They cant bowl unlimited bowls because if you had a good bowler that you wanted to use, you would have to use hime every 2nd over because the current bowler that bowls an over will have to bowl not the next over but the one after that one.
by far sachin has been bowled out the maximum number of timesin world cricket.As on 11th November 2010 sachin has been bowled out 65 times in odi cricket
I would guess it would be 'Phil Simmons'. He bowled 8 maiden overs (out of 10) in an ODI against Pakistan. His bowling figures for that match was 10-8-3-4 (10 overs, 8 maiden, 3 runs and 4 wickets).
The bowling team is required to bowl a mandatory minimum of 90 overs in a day. They can bowl more but very rarely do. Usually they have to go into overtime to fulfil the requirement.
rajistan royals
588 runs and the match was between England and India. But the run rate was not much as 155 overs were bowled in the match.
completed
Overs means number of balls bowled or going to bowl against opposite team.
The maximun is 2 hours a session plus a 15 minute innings break plus 5 minutes each innings for drinks
12 overs maximum a bowler could bowl in 1983 world cup. The games were 60 over games.
Ravinder Jadeja(CSK) 5-16 in 4 overs
In theory 450. Teams are required to bowl 90 overs a day. This target is often not met despite half an hour extra being added to make up for time. Also 2 overs are taken off for change of innings.