answersLogoWhite

0


Best Answer

Generally there is a fuel line, an overflow line, the air boot (from the filter) and one other thing I can't remember. A manual would be very helpful here :)

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What lines connected to carb on Honda crf 80 dirt bike?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Honda motorcycle repair manuals?

How do you set the carb on a 2003 Honda CR125, i have purchased a second hand bike but have no manual.


What the Honda hornet Sensor carb?

Sensor carb means, their is a heater on carb. It is used for very cold countries. Because when bike start it helps to heat fuel for sufficient temp.


How are the vacuum lines connected to the carb on a 1989 Toyota Tercel?

1989 Tercel does not have a carburetor, it is Fuel Injected. Wrong. My 1989 Tercel has a carb.


Honda 200s carb adjustment?

Factory carb settings for a 84 Honda 200s


What are some things i can do to make my 1984 Honda CRX faster?

well I have a 1984 crx myself what helped most was to eliminate the old carb and vacuum lines and went with a webber carb.


How fast would a Honda express go with a load of 150 lb?

I own a 1978 Honda Express and I weigh 145lbs. Mine tops out at 28mph. Every bike is different, and it also depends on how clean your carb is.


Where is the carb bowl drain nut on a 125 yamaha dirt bike?

The carb bowl drain nut is located on the bottom of the carb.


What is the Float adjustment for 087A keihin carb for a 550 Honda motorcycle?

22mm is the float height for this carb


What is the top speed of a 125cc pit bike?

will a 110 carb make a 125 pitt bike go slower


How come my 1983 Datsun won't idle?

could be a million reasons. ranging from bad fuel, vacuum lines not connected, plugged up fuel filter, bad/dirty carb.


How do you change the idle on your 1982 Virago?

since it is a carburated bike it will have an adjustment screw that presses on the arm of the carb where the throttle cable is connected. with the bike running turn the screw clockwise about 1/4 to an 1/8 of a turn until you reach about 900 to 1050 rpm. be sure to give the carb time to adjust after every turn of the idle screw. usually about 30 seconds to 1 minute.


What size carb is needed for a Honda atc 200x?

24mm