answersLogoWhite

0

To remove the seat on a Polaris XC 700, start by locating the seat release mechanism, which is typically a latch or bolts at the rear of the seat. If it’s a bolt, use the appropriate tool to unscrew it. Once the latch or bolts are released, lift the seat from the rear and slide it forward to detach it completely. Ensure to also check for any additional clips or fasteners if necessary.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

What is the horsepower of a 2002 Polaris XC SP 700 snowmobile?

Horsepower for a 2002 Polaris XC SP 700 is 139


What is the dry weight of the 1998 polaris xc 700?

498 pounds


What is the horsepower of a 1998 Polaris Indy xc 700 snowmobile?

Typically the 98 XC 700's HP number were in the 118-120 range


How fast does a polaris 700 go?

my dad had a 2000 polaris 700 xc sp and now i have one and they top out at 110 mph with no mods except studs


Is polaris 98 700 xc two cycle or four cycle?

Two stroke. oil injected.


What is the horsepower of a 2000 polaris xc sp 700 snowmoble?

not enough to beat my mach z


What is the weight of a 1998 polaris Indy xc 700 snowmobile?

The weight of a 1998 Polaris Indy XC 700 snowmobile is approximately 480 pounds (218 kg). This weight can vary slightly depending on specific configurations and any additional equipment. Always refer to the owner's manual or manufacturer's specifications for the most accurate information.


How do you set timing on polaris xc 700?

To set the timing on a Polaris XC 700, you will need to remove the ignition cover to access the stator. Use a timing light and connect it to the spark plug wire, then rotate the engine to find the timing mark on the flywheel. Adjust the stator position as needed to align the timing mark with the specified degree of advance, typically indicated in the service manual. Ensure all bolts are tightened securely before reassembling the ignition cover.


What does Polaris xc sp mean?

Cross Country Special


What should compression be on a 1999 polaris xc 700 snowmobile?

The compression for a 1999 Polaris XC 700 snowmobile should typically be between 120 to 130 psi for each cylinder. It's important to ensure that both cylinders are within 10% of each other for optimal performance. If the compression is significantly lower, it may indicate issues such as worn piston rings or a failing head gasket. Regular maintenance and checks can help maintain proper compression levels.


Is there a drain plug for the bottom end of the engine in a 1998 Polaris 700 xc snowmobile?

Yes, the 1998 Polaris 700 XC snowmobile has a drain plug for the bottom end of the engine. This plug is typically located on the lower side of the engine case and is used for draining the oil during maintenance. It's important to ensure that the oil is fully drained to prevent contamination and to facilitate a proper oil change. Always consult the owner's manual for specific details and maintenance procedures.


How do you wire a heated shield to a Polaris 700 XC XP?

To wire a heated shield to a Polaris 700 XC XP, first, locate the wiring harness for the heated shield, usually found near the handlebars. Connect the shield's positive wire to the positive terminal of the harness and the negative wire to the ground. Ensure that all connections are secure and insulated to prevent any short circuits. Finally, test the system by turning on the heated shield to confirm it works properly.