0
What else can I help you with?
If a drive shaft has a arrow on it which way should the arrow point?
Toward the front of the vehicle.
What is the shaft length of a 1979 Johnson model 15r79e?
Unless someone installed a long shaft kit on it at some point, it should be 15 inches.
How do you set timing on 4 cylinder ford contour?
you set timing by the marks on the cam shaft and the crank shaft. they should point at together to make it run right.
How do you replace u-joint in front drive shaft on Chevy Suburban 4x4?
It should just come out like the rear shaft, remove the 4 bolts on the front dif and the shaft should just slide out of the transfer case. I have a 98 suburban and it may require a bit of patience getting it around the exhaust pipe which is directly under the shaft.
What is output shaft sensor signal?
The output shaft sensor signal is used to determine the speed and rotation of the shaft. The allows for monitoring of performance and efficiency.
What size socket for axle shaft nut on 2006 cobalt?
The socket size for the axle shaft not, on a 2006 Chevrolet cobalt, is three-quarter inch. The socket should be a five-point socket.
What is the strongest point of a building?
The elevator shaft
Is it possible to lengthen a drive shaft on a Yamaha motorcycle?
Yes, it depends on what type of shaft it is to determine how your going to tackle the job.
Determine the maximum torque the shaft can transmit?
The maximum torque a shaft can transmit depends on the material, diameter, and length of the shaft as well as the operating conditions such as speed and applied load. To determine the maximum torque, you would need to perform a detailed mechanical analysis or consult engineering specifications for the specific shaft in question.
How can one accurately measure arrows for archery?
To accurately measure arrows for archery, use a measuring tape to determine the length of the arrow from the nock to the tip of the point. Additionally, consider the spine or stiffness of the arrow shaft, which should match the draw weight of the bow for optimal performance.
What are the parts of an arrow?
Fletching Nock Shaft Point
Runout on a shaft should not exceed?
.002 per foot of shaft
