Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What size tip does the shaft in a callaway diablo driver have?
Write your answer...
Still have questions?
magnify glass
Related questions

Can you increase the shaft diameter on a Briggs and Stratton horizontal shaft?

I am afraid not Depending on the size of the shaft on the thing you are putting on it is possible to get a bushing made to increase the size of the shaft. Go to your local machine shop and ask if they can make one.)

How do you move or reset the oil pump shaft to reset the distributor and rotor line on a 73 F250 460?

I cut and welded the correct size allen wrench to an old long screw driver shaft and used that to turn the pump. You can chuck it up into a drill to prime the pump also.

Weight of an F1 driver?

Depends on the size of the driver.

How do you fit a key to a shaft and pulley?

Make sure the key is the correct size for the keyway on both the shaft and pulley. Insert the key into the keyway on the shaft. Slide the pulley onto the shaft, ensuring that the key fits snugly into both the keyway on the shaft and the pulley.

What size socket for axle shaft nut on 2006 cobalt?

The socket size for the axle shaft not, on a 2006 Chevrolet cobalt, is three-quarter inch. The socket should be a five-point socket.

What size socket for a 97 Ford Escort drive shaft?


What size is the nut on the half shaft on 2003 cadillac sls?


What is hole and shaft basis system?

The hole and shaft basis system are pre-defined tables / methods in which you use to find tolerances. If you have a set hole size and wish to find the shaft diameter and tolerance required you would use the hole basis system. If you had a shaft at a set size and needed to find the hole size and tolerance required for it you would use the shaft basis system. If you need any more info on it you could try and google it or look it up in something like the machinist handbook (probable google it aswell)

How do you prepare a shaft to glue head on?

Once you have cut the shaft to the specific size you need, you then need to sand about 1-2 inches of the paint at the bottom of the shaft and smooth it to give it a good surface to stick to.

What size driver fits on a 25 tooth sprocket?

9 tooth driver

How long is a submarine shaft?

A submarine's main screw shaft length is totally dependent on the size of the vessel, but in general, anywhere from 30 to 50 feet.

Whatsocket size nut holding cv shaft on 99 grand am?