Best Answer

Consult the Taylormade website for full details of the club. But it will most likely be .580. Make sure you get the right grip size.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the butt diameter of a taylormade graphite shaft?
Write your answer...
Still have questions?
magnify glass
Related questions

Will graphite shaft extenders fit steel shafts?

It depends on the butt size of the steel club and how wide the graphite shaft butt is. It is not really ideal to mix the composition of shafts in this way as it will drastically affect the swing weight. Yes it is true there are matrix shafts which have steel and graphite but these have been specifically designed for their purpose and work well. You would be best going and getting steel shaft extensions they are cheap enough.

How do you extend graphite club shafts?

There are extensions you can insert in the butt end of the shaft (after removing the grip) that can be trimmed to the desired length and re-install the grip. This must be done carefully, as some graphite shafts can crack easily.

Can you replace the grips on Taylor-Made bubble shaft with golf pride tour wrap grips?

Yes, you can. The bubble shaft is thicker below the grip, but has a normal diameter at the butt end.

How can you tell what the shaft flex is on Ping eye 2 irons?

Take the grip off. If there is a green mark at the butt end of the shaft the shaft is stiff.

How is a computer like a living thing?

butt ugly shaft rico

What is a shaft in lacrosse?

The shaft in lacrosse is the stick part. The butt is the rubber stopper on the end of the stick. The head is the plastic part which has the pocket. The shaft is the part of the stick where you hold it.

The shaft flex is measured by?

Shaft flex is determined by the vibration frequency-- this is measured by fixing the shaft's butt and attaching a 10-ounce weight on its tip and then vibrate it to its vertical direction.

What is an example of alliteration in Romeo and Juliet?

"Blind bow-boy's butt-shaft".

Who said blind bow-boy's butt-shaft in romeo and Juliet?


What are some alliterations by William Shakespeare?

"the blind bow-boy's butt-shaft" (from Romeo and Juliet)

How do you build a pool cue shaft?

The simplest pool cue shafts are simply turned on a lathe following a template to produce the 13 mm or 14 mm tip, followed by the taper, and then to the mating surface to the butt. The proper mating insert is selected and the shaft is drilled and it is inserted. The tip is applied, the tip properly turned and shaped, and the shaft is complete. In most cases, the shaft is finished with the butt however.

What part of the screwdriver is the wheel and axle?

the part of the screwdriver is nothing its not a wheel nor axle its a butt