There are extensions you can insert in the butt end of the shaft (after removing the grip) that can be trimmed to the desired length and re-install the grip. This must be done carefully, as some graphite shafts can crack easily.
Yes. This has been done.
Don't try if you are not a professional. It demands special tools and special knowledge if it can be done at all.
Remove the driveshaft From the truck. Mark the driveshaft on both sides so that when you put it back together it will still be balanced. Slide the 2 shafts apart and then take a hammer and a punch and lightly drive the bearing off the shaft. install the new on and slide the shafts back together. reinstall and walla your are done.
Warrior all the way, they are way more durable than brine. Brine shafts dent and bend to easly which you don't want, you want a stick that will last a while and get the job done.
you'd have to change your axle shafts, different bolt pattern.
Black magic can be done anytime and anywhere.
Graphite is mined in an open pit or underground. In an open pit graphite is extracted using bulldozers, and front end loaders to break up and left the product. It is extracted through drilling when it is done underground.
Anywhere you want pierced.
where can recycling be done?recycling can be done anywhere in australia weather you go to the recycling store and recycle bottleor can.
replacing both half shafts will take about 6 hours, if you have never done it before.
The sacrament can be done anywhere as long as there is a priest to do it.