You need a a spoke wrench to get the spoke out of the spoke nipple by the rim. The nipple screws on and off just like a regular nut. Undo the nipple and bend the spke a little until it pops free. Unlace the spoke from where it's intertwined with the other spokes until it can be released from the hub. Bring the spoke with you to thebike store and buy a replacement, then repeat in reverse. Tension spoke until it gives of the same tone as the other spokes then plucked.
To put spokes on a bike rim, start by inserting the spokes into the hub holes. Then, thread the spokes through the rim holes and tighten the nipples to secure them in place. Repeat this process for all the spokes until the wheel is fully laced. Finally, adjust the tension of the spokes to ensure the wheel is true and balanced.
put my mum on the seat and grind
Change the wheels with specil ski wheels i think its called ski bike.
axle mounted, yes.
A 20 inch tire.
It´s the Stem, it holds the bars and match with the frame with the help of a headset.
Yes, pegs can be put on any BMX Bike. You will need a socket wrench to put pegs on certain bikes how ever.
Depends on what's already on there, what's available, and how much clearance the bike has at the fork and frame.
Too many steps to answer here, go to www.parktool.com, www.sheldonbrown.com or www.bicycletutor.com for more.
u could cut it up then make all the bits smaller and then put weld it back together again
No, you cannot put pegs on a mountain bike for stunts and tricks. Mountain bikes are not designed for this type of use and adding pegs could compromise the bike's performance and safety. It is recommended to use a BMX bike for stunts and tricks instead.
Not a sprocket only, but you can buy a 23-tooth freewheel that should fit.