answersLogoWhite

0

For simplicity you would need a shaft puller, a propane blowtorch and a butane blowtorch as well as a Stanley knife. You need to use the propane blowtorch to soften the ferrule before you remove it by putting the Stanley knife flat with the shaft and cutting it off. You the put the club in the club puller and crank it until it is quite tight, you then use the butane blowtorch to soften the old epoxy resin, you will need to keep the blowtorch moving to avoid any damage, it may take about 30-40 seconds and you will see it loosening. You can then simply pull the head off with ease, the head will not be hot as long as you handle it at the toe. You can use the Stanley knife to remove some of the epoxy from the shaft. For a steel shaft repeat the above, but use the propane blowtorch to soften the epoxy resin as it burns hotter. However the easiest way is to take it to a Golf shop and get them to do it, if you buy the shaft off them it will be rather cheap, but there may be a nominal charge if you simply bring a shaft for them to fit.

User Avatar

Wiki User

15y ago

Still curious? Ask our experts.

Chat with our AI personalities

BeauBeau
You're doing better than you think!
Chat with Beau
CoachCoach
Success isn't just about winning—it's about vision, patience, and playing the long game.
Chat with Coach
FranFran
I've made my fair share of mistakes, and if I can help you avoid a few, I'd sure like to try.
Chat with Fran
More answers

You can use wire wool or if it is on the entire club, like a rusty wedge or something, you can soak it in coke overnight.

User Avatar

Wiki User

15y ago
User Avatar

oil it

User Avatar

Wiki User

12y ago
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get rust off a golf club head?
Write your answer...
Submit
Still have questions?
magnify glass
imp