answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you find the center of a shaft?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What tool is used to find the center of a shaft or other cylindrical work?

A center finder is commonly used to find the center of a shaft or cylindrical workpiece. This tool typically has two prongs that are placed against the outer circumference of the workpiece, allowing the user to accurately mark the center point.


Which vehicle has a 53 inch drive shaft center to center of the drive shaft U-joint?

98 chevy s10


What is axial alignment in rotating machines?

Shaft center to center


What is a shaft that attached to a center of a wheel?

An axle is attached to the center of wheels.


What is the position of the shaft in pelton turbine?

In the center of the wheel shaft is connected to the spoon away.


What is an eccentric shaft?

A shaft is usually longish bit of rotating machinery, made to transfer rotating power. Eccentric means off-center. Either the shaft isn't round, or it's not mounted at the center of wherever it it.


What is an axle for?

It is the center shaft of a rotating wheel or gear.


How do you calculate center of gravity for a taper shaft?

To calculate the center of gravity for a taper shaft, you would need to consider the varying cross-sectional area along the length of the shaft. You can use an integral approach to determine the centroid of each cross-sectional area and then calculate the weighted average of these centroids to determine the overall center of gravity of the taper shaft. Alternatively, you can simplify the taper shaft as a series of smaller sections with uniform cross-sections and calculate the center of gravity for each section, then determine the overall center of gravity using the weighted average of these section centroids.


How do you get the tail shaft out of 350 turbo trans how do you get it out?

If you are talking about the SPLND STEEL center shaft that the driveshaft slides over, Then you will have to take the transmission APART to remove the shaft.


What is a center bearing?

That is a bearing in the centre of a crankshaft or drive shaft.


How do you find diameter of a shaft when bearing no is given?

How do you find dia meter of shaft when bearing no is given?


Will a 4X4 4L60E interchange with 2X4 4L60E?

NO. The 4x4 transmission CENTER shaft is longer then the 2-wheel drive tranmission center shaft so the transfur case will fit on it. They WILL NOT INTERCHANGE.