0
What else can I help you with?
What does it mean when the brake light randomly comes on and off on a 1998 Corolla?
try releasing the brake
What would cause the brake light to come on a 1986 Oldsmobile after replacing the master cylinder?
check that the emergency brake pedal is completely up.If ok disconnect the electric cable from the emergency brake pedal. i think is brown in color if light turns off the problem is there.
Brake pedal almost goes to the floor before it engages the brakes?
Probable causes: Low or no fluid in reservoir; Worn brake pads/shoes; Air in brake lines; Leaking brake line.
Can you e-brake drift with an electric e-brake?
no
How too change brake cable on TD15 dresser bulldozer It goes around two pullys and engages the brakes when you push pedal in?
To change the brake cable on a TD15 Dresser bulldozer, first ensure the machine is safely parked and secured. Disconnect the old brake cable from the brake pedal and the pulleys, noting how it is routed. Install the new cable by threading it through the same path around the pulleys, then connect it to the brake pedal. Finally, test the brake pedal to ensure proper engagement and adjustment of the cable tension as needed.
What is the purpose of the spring brake chamber?
1: It serves as a parking brake 2: It serves as an emergency brake, and engages the brakes in the event that there should be a loss of pressure in the primary air system.
What would make the brake lights randomly flash when the car is not running?
the alarm
Remove brake light on a 2005 chev aveo?
remove the power chip or disconnect the battery and then disconnect it manually!!
How do you disengage buzzer for emergency brake 1984 fiero?
Easiest would be to disconnect the wire at the emergency brake handle.
How do you regulate clutch in Toyota Corolla?
Disconnect you brake system and die
What is the function of the spring brake system?
It locks the brakes when the vehicle or trailer is not in use. It also engages if air pressure is suddenly lost.
How do you change a brake line on a 98 ford escort?
Disconnect brake line at the nearest junction Disconnect brake line at the affected wheel cylinder Route new brake line same way old one was Connect both ends Bleed the wheel cylinder on that line MAKE SURE MASTER CYLINDER DOES NOT RUN EMPTY
