answersLogoWhite

0

What else can I help you with?

Related Questions

When a 6cm piece of ice is placed in a beaker?

When a 6 cm piece of ice is placed in a beaker, it will start to melt as the surrounding temperature warms it up. As the ice melts, it will change from a solid to a liquid state. This process continues until all the ice has melted, at which point it will be completely liquid water.


What is a beaker placed on top of?

a tripod


How does is the temperature of beaker measure in water?

The temperature of a beaker is typically measured using a thermometer that is placed in the water inside the beaker. The thermometer will provide a reading of the water temperature, which indirectly reflects the temperature of the beaker as well.


Why was there no transmission of light after the beetroot had been placed in water at 100C?

it melted


Where should a thermometer be placed in a beaker?

Hold it by the top or use a clamp. But make sure before you take the temperature you stir the liquid around in the beaker first and that you do not let it touch the bottom of the beaker as the glass will be hotter than your liquid.


Why does a lit candle go out when a inverted beaker is on it?

When an inverted beaker is placed over a lit candle, the flame goes out due to lack of oxygen. As the candle burns, it consumes oxygen and generates carbon dioxide and water vapor. When the beaker is placed over the candle, it creates a closed system, limiting the supply of oxygen needed for combustion, causing the flame to extinguish.


After a salt cube is placed into a beaker of water what will happen?

beakers are not made of water, they are made of glass.


What changes in egg when placed in saltwater solution?

the egg become bigger if they put in vinegar and beaker


A potato cube is placed in a beaker filled with hot salt water and another potato cube is placed in a beaker filled with cold salt water?

The hot saltwater will cause the potato cube to absorb the water due to osmosis, while the cold saltwater will cause the potato cube to release water. The difference in temperature affects the rate of osmosis – higher temperatures increase the rate, while colder temperatures decrease it.


Where should a beaker be placed with respect to the flame for the most efficient heating on Bunsen burner?

A beaker should be placed directly above the blue cone of the Bunsen burner flame. This is the hottest part of the flame, and it will provide the most efficient heating for the beaker. Placing the beaker too close to the flame can result in uneven heating and potential breakage.


What might happen to a heated beaker made from glass that does not contain boron if the beaker were placed in a pan of iced water?

Without boron, the glass beaker may not be able to withstand sudden temperature changes and could shatter due to thermal shock when placed in iced water. This is because borosilicate glass, which contains boron, has a lower coefficient of thermal expansion and is better suited for rapid temperature changes.


Are there any liquids which would change to gas if placed in a tube and put into a beaker of boiling water?

yes