Lapping the valve is done to ensure a proper seal between the valve and its seat, enhancing engine performance and efficiency. This process involves using a fine abrasive compound to grind the surfaces, removing any imperfections or carbon buildup. It helps improve compression and reduces the likelihood of leaks, ultimately contributing to better engine longevity and reduced emissions.
'Lap windings' apply to motors, not transformers.
Lap reinforcement is needed because if lap is not given in a steel structure,that portion will be filled only with mass concrete and it will not attain the expected strength,so inorder to prevent that we can provide a lap rod whose length is 50D i.e 50 times the diameter of the rod.
I believe the Dutch Lap is the one with the beveled edge at the top of the board, which creates shadow lines. The board lays flat on the vertical. Lap siding has flat boards overlapping each other on an angle. Beaded lap has a rounded, beaded edging detail at the bottom of the board. The boards lay on a slight angle overlapping each other.
the angle of the pulley
that is such a stupid answer
Lapping the valves is the final step in assuring a tight seal between the valve and the valve seat.
Is the time when intake and exhaust valve remain oper during the exhaust stroke.
A lapping plate shaped to match the valve seat is used with lapping film or compound. On a large valve, it would be turned with a drill. On a small valve, by hand.
Is the time when intake and exhaust valve remain oper during the exhaust stroke.
Your sister can sit ON your lap not IN your lap.
Lap. They are a Caine or dog.
lap
Phar Lap Phar Lap Phar Lap
phar lap
Phar Lap was a thoroughbred.
i put the laptop on my lap.
Dogs will "lap" their water. To lap means to take up liquid with the tongue. Dogs actually fold the tip of their tongue backwards so the top of the tongue penetrates the surface of the water.