0
What else can I help you with?
Why transformer is used?
A transformer used to step up or down the value of voltage.
How do you improve the ir value of the transformer?
Moisture entered inside the transformer coil may cause loss of IR value. IR value can be increased by removing the moisture. Keep the transformer in a hot air chamber for sufficient time to vaporize the moisture.
What is the ampere range value of transformer?
This typically has to do with how many amps you can safely pull from the secondary of the transformer.
What is transformer earth resistant value?
5
What is a set down transformer?
A stp-down transformer steps voltage down from a high value to a low value. Transformers only work with AC.
What component step down the voltage to the low voltage value?
Transformer
What is the difference between a transformer and a rectifer?
A transformer is used to change the value of a voltage applied to the transformer's primary winding to a different voltage value taken from the transformers secondary winding. A rectifier is used to change an alternating current value to a direct current value.
What will happen if a new branded 132KV transformer is charged at the IR value of 150Megaohm between HT winding and Earth remaining IR values being found infinity?
Sir I am Imran khan in nepal my problem is 6000KVA Step down Transformer is not charging. Transformer Pri- 33000V /105A Sec- 6900V / 502Atransformer all test (open & short circuit ) good . but problem is HT(IR)= value this time IR value 50M ohmBefore 3days HT(IR) = value is 7000M ohm suddenly start Transformer result is Transformer not charging & HT(IR) value is down 50M ohm.
What is the maximum value power capacity of dry type transformer?
What's the maximum value power capacity of dry type
What is the difference between the center tapped transformer and ordinary transformer?
An ordinary transformer has two input/output terminals but a center tapped transformer has 2 input and 3 output terminals. One is taken from the center for a ground connection. This causes it to get 50% of the actual value. And ordinary transformer contains 2 windings. An autotransformer has one.
What is meaning of SK value in transformer oil?
It shows the Purification during the filtration of crude oil.
What are the conditions for operate the three phase transformer?
The BDV value of the transformer oil should be above 50kv winding resistance value should me minimum depends upon the KVA Of trans earthing should be provide for the trans air should be release inside of the tranformer insulation level should be check to operate the transformer these are all the initial condition to operate the trans
