answersLogoWhite

0


Best Answer

looking at the timing marks from the top left to right you have 5 degrees after top dead center, then top dead center then 5 degres 10, 15 then 20 befor top dead center. the timing is 7 degrees before top dead center

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What marks do you use to time a ga15 Nissan motor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you time a ga15 Nissan engine?

nissan ga15 timing diagram


What are the timing marks on a 1996 Nissan pickup?

On your top and bottom pulleys ,you have timing marks,they should line up when time is correct.


Where are the timing marks on 2000 Chevrolet Silverado 6 cylinder?

How to time a 6 cylinder motor


How do you change freeze plugs on 91 Nissan 300zx?

you have to remove the motor and it still a painfull time consuming job


Who invented the Nissan skyline?

The first Skyline car was developed in 1957 by The Prince Motor Company in Japan. The company was taken over by Nissan in 1966 and the car was continued. Production continues up to the present time.


Where and what are the timing marks on a Nissan 240sx?

Timing marks determine if the car is set on TDC(Top Dead Center). Just to make sure it is in time use a Timing Light. The timing marks are located on the sprocket under the valve cover and on the crankshaft. Timing marks determine if the car is set on TDC(Top Dead Center). Just to make sure it is in time use a Timing Light. The timing marks are located on the sprocket under the valve cover and on the crankshaft.


How do you time crank shaft gears for a 1993 Nissan 240 SX?

go to your local library and get service manual for that engine it will show you a picture of the timing marks and explain how to line them up.


Type of oil used for 1992 altima Nissan?

5w 30 4 qts. do not use syntetic unless the motor has been running on it for a long time


How do you fix ac blower motor on a 95 Nissan altima when it only blows high?

Check to see if the switch is any good . Most of the time it is the switch.


Ok this is what i did i put a new crank shaft in my 1982 Nissan Datsun truck now it is out of time how do i put it back in time please help thank you?

There are timing marks for the crankshaft and cams, you need to make sure they are all lined up perfectly when you reassemble the engine.


Timing marks set the dist 1991 Chevy?

Wich marks can u use to set it on time if the marks are erased


Where are the water pump and thermostat in a 1992 Nissan Sentra and how do you change them?

located between the firewall and the motor on the trans side takes a bit of time and a lot of trouble but you can do it w/o moving the ac lines