As roughly recorded in the 2003 service manual page 22-54: Hold down the trip reset button while turning on the ignition key. Continue to hold the button for a few seconds until the light goes out. It is then reset.
For the 2006 model: Turn ignition on. While maintenance display is on, press and hold the trip reset button and hold until entire maintenance display blinks (roughly ten seconds), let go while whole maintenance display is blinking, then again press and hold the trip reset button until the oil life indicates 100% (roughly ten seconds more).
You can reset the 2007 Avalon maintenance light by setting the oil life to 100 percent. When the oil life display is on your monitor, hold in the scroll button until it goes to 100 percent.
How do you reset the oil life light on Mercury Mariner? Dealer didn;t reset at oil change & we are out of state now. Thanks
Turn on the ignition but do not start vehicle. Your engine and oil light will come on. Press on the accelerator three times and hold it down until oil light disappears. You have reset the oil life indicator.
Easy... You scroll up or down on the info button until you come to oil life and press the reset button atleast 3 or 4 times... Note that you can not reset this if oil has not been changed recently
when you have it on the message that says engine oil life xxx press and hold the clr button and it will reset back to 100%
Reset the 2007 Civic oil light 1. Ing switch on 2. Press Sel/Rest button until oil life indicator is displayed 3. Press the Sel/Reset butto for about 10 seconds. The engine oil life and maintenance item codes will blink 4. Press the SEl/Reset button for more than 5 seconds. The maintenance item cod(s) will disappear, and the engine oil life will reset to "100". - From the Owners manual page 216
With the ignition OFF press and hold the odometer reset button while at the same time turning the ignition to the on position without starting the engine. After 5 seconds the light will reset.
(This is quoted directly out of the Cadillac Service Manual Vol. 2)"After an oil change, the index may be reset by displaying the oil life index and then pressing the 'RESET' button for approximately 5 seconds. When the value is reset, 100 will be displayed for the Oil Life Index."
I have a 2007 and I have to push the trip button until the oil life indicator shows. Once it does I have to push and hold the button until it says reset.
You can reset the service light by bringing of the oil life monitor on your display. Hold the scroll button in until the oil life goes to 100 percent. This should reset your service light.
press info botton until you come upon "oil life" then press and hold the reset button for about 5 seconds
Don't know if this works in a 99' but I have a 97'. You have reset the "oil life remaining" readout and this will reset "change oil" indicator. Scroll thru your various readouts (rpm's, water temp, battery volts, etc.) till you see it and then just press reset. Hope this works for you.