I will provide an answer to the rear light on 2007 CTS (which I presume is the same for all current models). The nuts needed to be unscrewed are accessed behind the body panels in the trunk. The body panel can be pulled away by unscrewing the tie downs (black plastic knobs) and moving the cover from the spare wheel well. Note: be careful unscrewing the nuts so they aren't dropped. Although the void in the rear corner is not deep, you will may have to clear some other components bolted to the body in order to get your hands into the void. Once the nuts are removed, the rear light cover can be pulled away from the body. The bulbs can be accessed once the cover is pulled away from car body.
ow to replace brack light switch 2006 cadillac cts
get a new light bulb ,take the cover off the light bulb that's broken and replace it.
Carefully
how to replace map light bulb in a 2006 pontiac torrent
how do you replace license pate light on 2006 pontia g6
# Remove the trunklid latch trim cover # Remove the electrical connector # Push in on the tabs and push light out of trunk
How do it replace the stop light bulb
How can I replace the climate control light on a 2006 Chevy Equinox? Both my heat control and fan speed light are out.
To change the front signal light on a 2006 Chevy Express van, remove the bottom plastic cover that runs along the grill. Pull the push pins that hold the light in place. Remove the bulb and replace with new.
Disconnect the battery for 30 seconds
you have to replace a light control box
I have a 2006 lincoln ls sport in which the 3rd brake light cover isn't connected properly. When I drive I can see out of my mirror that it's moving. Is there a way to keep it from moving?