if your under miles its under warrenty
how do you replace license pate light on 2006 pontia g6
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
my name is Jesse fondotsto replace a license plate light you first have to open the trunk of the car take out the carpet on the top of the trunk after that you will see two little black screws you take them out after you do that the silver peice will come off but before you can replace it you must take the two little screws out that are located right above the license plate. your welcome!
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
How do you change the liscence plate light fuse
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
what is the number for the fuse to change the rear license plate light. and is it the fuse box under the back seat or under the hood? The plate light is protected by the parking/tail light circuit.
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
Superdiscount LEDs has a tutorial out how to change the license plate light to an LED light. Its pretty general how to do but a lot easier with pictures. Heres to step by step links that should help you! http://www.superdiscountleds-how-to-install-leds.webs.com/ -OR- http://www.go-audi.com/14083-audi-q5-how-do-i-replace-license-plate-bulbs.html Source: www.superdiscountleds.com
there are two spots above the license plate where the lights go on each one there should be a spot where you can push the cover in and then just pull out at an angle
To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.